1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 176Get this manual
18Move the pistons up so that the connecting rod bearings are against the crankpinPlace one bearing half between crankpin and rod and one on top of crankpinOrient and place the connecting rod cap on the needle bearingsOil threads of the rod cap screwsInstall and tighten the screws in stages to final torque of 60-70 inIbs(7-7,5 Nm)19Place remainder of the 30 needles on center journal of the crankshaftPlace bearing liner on needles aligning dovetails L!!J flange of the cylinder block with OMC Cleaning Solvent and
let air dry1321 21Apply OMC Locquic Primer to the mating flange of the crankcase and let air dry