1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 174Get this manual
Assembly
r::-=J Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard LubricantINotel Use new gaskets, seals, and O-rings during assembly1If removed, install wrist pin bearing using OMC Bearing Installer and Remover, PIN 32764522
When installing wrist pin bearing, the oil hole must align with the hole in rod end
12311241 2
Using OMC Cone, PIN 333142, and Driver, PIN 333141, install one snap ring in groove of piston When installed, gap of the ring should be positioned opposite groove in the piston'" To avoid personal injury, use insulated gloves when han0 0
i dling pistons that have been heated
1251 3Heat the piston to 200400 (93204 C)Using OMC Piston Cradle, PIN 326573, and OMC Pressing Pin, PIN 333141, oil the wrist pin and start it into the piston opposite