1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 146Get this manual

1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 146

CleaningAll Models
Before inspecting or assembling power-head, all internal components must be perfectly clean and free of contami-

1Remove any carbon accumulation from exhaust port areas2Remove any carbon accumulation from cylinder head combustion chambers3If cylinder walls are glazed from extended use, use medium grit hone to resurface wallsUse slow RPM to achieve strong "crosshatch" pattern for best oil retention and ring sealing
To avoid piston or cylinder block damage, restore the chamfer to all port edges using ball hone or other suitable

i gloves when using OMC Gel Seal and Gasket Remover
To avoid personal injury, wear eye protection and rubber

rv 4Use OMCadhesives,and Gasket Remover to remove all traces Gel Seal of gaskets, and OMC Gel-Seal" sealant from the

Back to 1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual