1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 114Get this manual
Ohmmeter TestStop Button INotel All ohmmeter tests must be performed with the engine NOT running 1Most steering handles contain combination stop buttonemergency stop device When the clip and lanyard assembly is removed, the emergency stop switch is in the STOP position When the clip and lanyard assembly is installed, the emergency stop switch is in the RUN position To stop the engine when the clip and lanyard assembly is in place, press the stop button inward until the engine stops2Install the clip and lanyard1sl 3Calibrate an ohmmeter on appropriate scaleConnect meter leads between ignition plate end of EJ connector, terminal liE", and clean engine ground The meter must show high reading4Momentarily, press inward on the stop button The meter must show low reading5Remove the clip and lanyard The meter must show low reading & To avoid sudden loss of control, replace the stop button assembly if your test results vary