1994 Johnson/Evinrude Accessories Service Manual, Page 44Get this manual
126! 25Install cam assemblyPosition friction cap onto adjuster engages cam slotscrew and make sure the driveshaft pin Secure with flat washer and screw through the bushing127! 26Install friction cap nutApply OMC Moly Lube to the throttle arm spacer and install12S! 27Install throttle arm with pin in the slot as shown to position one control cable on each side of control(If throttle arm pin is positioned in slot, both control cables will be on the same side of the controL) Install washer and screw and tighten securelyOMC Snap-InCablesInstallation
Throttle Cable
1Lubricate shift and throttle cable ends with OMC TripleGuard grease
rn 2Install the trunnion anchor in throttlethe crescent holes one of (marked "OMC") located below the leverPlace the