1994 Johnson/Evinrude Accessories Service Manual, Page 22Get this manual
15Move control handle to align rear set screw with access hole in housingInsert hex wrench through hole and tighten second set screw16Shift lever must be in NEUTRAL before reassembly of remote controlPosition neutral start switch on center of neutral start cam while making sure neutral lock slide of control handle engages notch in index plateControl handle should be unmovable without releasing neutral lock slideIf the neutral lock slide does not engage notch, reposition the control handle or the index plate
17To assemble control, lay cover half on bench and place housing half over itPlacing cover flat on bench keeps cable pins from falling outTake care to properly pilot the electrical cable grommet into the housingTighten the three cover screws and torque them to 40-50 inIbs(4,6-5,5 Nm)