1994 Johnson/Evinrude Accessories Service Manual, Page 21Get this manual
cr CD .10,0C02817
7Push core wire Q) (from engine end) through wire clamp Q) until wire is flush, 132 in(0,8 mm), with end of casing guide '
[] 8Turn in set screw on large end of wire clamp until it touches core wire, then tighten one more full turn to kink and position core wire
9Grease trunnion pocket in housing halfLift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocket10Position throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screw11The throttle lever must be in the idle position before reassemblyMove the throttle lever forward, toward the front of housing half, until it contacts the stop