1994 Johnson/Evinrude Accessories Service Manual, Page 18Get this manual
OMC Snap-In CablesInstallation
1Remove three cover screws from remote control and pull the two halves apart
[]] rn 2Place housing half and all points shownflat surfacecover half on Apply OMC Moly Lube grease to in figuresGrease the threaded holes in the coverThrottle Cable 3Lubricate cable ends with OMC Triple-Guard grease4To install throttle cable in housing half of control: Move throttle lever out from behind plastic plate to expose the hole in the lever
In Do not remove plastic separator plate from housingIf it