1994 Johnson/Evinrude Accessories Service Manual, Page 17Get this manual
123114Place neutral start switch mounting plate over detent spring, and place switch on plateSecure with screws and torque them to 15-20 inIbs(1 ,7-2,3 Nm)1241 15Place complete friction adjustment leverspring, and knob in the control1251 16Install retainer plate with screw and torque screw to 25-35 in Ibs(2,8-3,9 Nm)17Check to be sure no wires are pinchedLubricate shift lever post and three assembly screws with OMC Moly Lube grease18Reassemble two halves of remote control, taking care to properly pilot the electrical cable grommet into the housingTorque screws to 40-50 inIbs(4,6-5,5 Nm)19Install control handlePull the neutral lock slide up, and install handle spline into spline of remote control so slide will engage notch of index plateInstall Allen head screw and torque to 100-120 inIbs(11-14 Nm) & 20Neutral lock slide in control handle must engage neutral