1993 Johnson Evinrude "ET" Electric Outboards Service Manual, P/N 508280, Page 132Get this manual
[] 5Press pin through bow arm, assembling hook, and spring on pin under bow arm rn 6Thread rope through latch and tie overhand knot in rope end[] 7Secure rope end to rope with tie strapLatch Plate Service]1Remove latch plate screwsRemove latch plate and any shims
2Apply OMC Screw Lock to latch plate screws and installTorque screws to 30-35 inIbs(3,4-4,0 Nm)
3If clearance between hook and latch plate is greater than 0.005 in(0,2 mm), install shims as required to reduce clearance to 0.005 inor lessBracket, Links, and Motor Rest Service 1Disassemble and replace parts as requiredRemove set screw before removing motor tube clamp pin or link-to-base pinsApply OMC Triple-Guard grease to all pivots as parts are assembledWhen replacing set screws, apply OMC Screw Lock to screw and installTorque screws to 25-35 inIbs(2,8-4,0 Nm)