1993 Johnson Evinrude "ET" Electric Outboards Service Manual, P/N 508280, Page 97Get this manual
Installation
1Apply Wakefield Thermal Joint Compound to new resistorThe compound should fill all space between the resistor and the adapter, and it must be applied to the base of the adapter where the resistor is seated to provide effective heat transfer
[]] 2Install resistor with terminal"R" positioned at the bottom[]] 3Connect motor tube wires to resistor bobbin as follows:
Connect the greenwhite wire to terminal "GW" Connect the red wire to terminal "R" Connect the green wire to terminal "G"
4Install motor as follows:
Install new O-ring in groove of motor
Slide heat shrink tubes motor