1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 350Get this manual
1251126127Thread the end cap into special tool, tighten athe end the cylinderUsing torque wrench installed 90 to the cap to torque of 18-21 ftIbs(24-28 Nm)Tighten band nut securelyDo not lay the tilt cylinder on its side because oil will leak out of the band nutPlace the two nylon bushings back in the large hole at the base of the tilt cylinderPosition the tilt cylinder in the manifoldInstall both upper and lower hydraulic lines finger tightBe sure there is an O-ring on each end of the hydraulic linesTighten the fittings on the ends of the hydraulic lines to torque of 14-18 ftIbs(19-24 Nm)
27128Position the manifold as shownInstall the tilt cylinder pin