1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 339Get this manual
23 COA2433
20 cUsing sharp screwdriver, pry the scraper out of the end
capDiscard the scraper
f211 dPry the a-ring out of the end cap using flat toolOnce the
scraper and a-ring have been removed from the end cap, the outside a-ring can be removedClean the cap thoroughlyDiscard the a-ringscapThe scraper is installed with the lip facing out and can easily be pressed in with your fingers or with large flat tool in the palm of your hand
22 eOil and install new a-ring and scraper CD in the end
23 fOil and install new a-ring Q) on the outside ofthe end cap24 gUsing wire brush, clean all Locktite material from the 25 hClean the threads on the rod with
OMC Locquic PrimerSlide the piston onto the rodPlace new small a-ring over the threads
threads on the tilt rodUsing OMC Tilt Cylinder Seal Protector, PIN 326005, slide the end cap onto the rod