1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 316Get this manual

1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 316

Trim Sending Unit Adjustment 1Tilt the engine and engage the mooring bracket
'11 2Temporarily, install PIN
holesending unit can be pivoted
387278 thrust rod in the No.3 until only snug, so the

f21 3Loosen the sending unit screws

4Disengage the mooring bracketLower the engine against the thrust rod
'3l 5Observe the trim gaugeIf the needle does not show center
positiontilt the engine up and adjust the sending unit by pivoting it up or down6Lower the engine against the thrust rod to verify adjustmentRepeat Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the thrust rod

Back to 1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285