1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 312Get this manual
135120Using OMC Rod Holder, PIN 983213, clamp rod tightly in viseLubricate end cap and slide it on the rodInstall wear plate on rod end and torque to 84-108 inIbs(9,5-12 Nm)Assembly '111Lubricate five new pump manifold a-rings and place in cylinder body2Attach pump manifold assembly to cylinder body with three Allen head screws, and torque to 60-84 inIbs(7-9 Nm)
i the valve all the way into the manifold and torque to
3Lubricate and install the manual release valveThread
45-55 inIbs(5-6 Nm)Install the retaining ring with the sharp edge of the ring facing outr:1l4Lubricate new motor a-ringPlace it on the motor and L!.J attach the motor to the pump manifold assembly with four Pozidriv screwsTorque the screws to 35-52 inIbs(4-6 Nm)Secure wire shield to pump manifold assembly