1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 272Get this manual
43 C02817 COB5633
1431 7Push core wire CD (from engine end) through wire clamp Q)
until wire is flush, 132 in(0,8 mm), with end of casing guide
1441 8Turn in set screw on large end of wire clamp until it touches
core wire, then tighten one more full turn to kink and position core wire
Grease trunnion pocket in housing halfLift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocketPosition throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screwlever must be in the idle position before reassemblyMove the throttle lever forward, toward the front of housing half, until it contacts the stop CDI Place casing guide of shift cable between halves of shift lever in its pocketGrease outside surface of wire clampInsert clamp through shift lever and casing guide