1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 271Get this manual

1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 271

OMC Long Life TM CablesInstallation OMCCable Adapter Kit, PIN must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control, and pull two halves apartr:;:;t 2Place housing half and cover half on flat surfaceApply OMC Triple-Guard grease to all points shown in figuresBe sure to grease the three cover screws' threaded holes

COB5630

1381 3Lubricate outside of brass sleeves at control end of both
remote control cables with OMC Triple-Guard grease
1391 Place trunnion caps over cable trunnions and casing guides over cable sleeves

1401 Using a
3 32 inhex wrench, start the set screws into each end of both control end wire clamps
1411142 To Begin cable installations with housing half of control6install throttle cable, make certain fast idle lever is

Back to 1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285