1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 242Get this manual
Assembly 1Lubricate the armature shaft bearing surface with one drop of SAE No10 oilLubricate pinion helix on armature shaft with OMC Starter Pinion Lube1sl 2If removed, install retaining ring and washer on drive end of armature shaft1sl 3Assemble drive end cappinionspringand spacer to drive end of armature shaftInstall new locknutUsing strap wrench to prevent damage to armature, tighten nut to torque of 240-300 inIbsor 20-25 ftIbs(27-34 Nm)4Assemble armature to frame and magnet assembly, aligning marks on drive cap end and frameInstall insulated brush and terminal set in commutator end cap with long lead in slotPosition the insulatorsflat washer CD, lock washer Q), and nut as shownReversing these brushes will cause starter motor to run backwards 19l 5
1101 6Install brush holder (0, brush springs, and ground brushes
f11'l 7Assemble commutator end cap to frame and field, aligning notch and rib suitable tool for holding brushes in place can be made from putty knife