1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 222Get this manual

1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 222

r;] 1,l 9Assemble remaining shims, new tab-lock washer, and impeller nut onto driveshaftTorque impeller nut to 16-18 ftIbs(22-24 Nm)Use new tab-lock washer each time, and bend tabs around driveshaft nut to secure l!J

l!J Gasket Sealing Compound to threads of six retaining screws
and install them finger tight only
Assemble intake housing to main housingApply OMC

Check for any rubbing or binding between the casing liner and impellerIf clearance is greater on one side, verify that the intake housing is centeredTorque screws in crisscross pattern to 10-12 ftIbs(14-16 Nm)
[!] 11 Repeat Step to verify adjustmentGate Adjustment

1Move remote control handle to NEUTRAL detent

Back to 1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285