1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 206Get this manual
f181 21Position the driveshaft thrust bearingthrust washer , and shim(s) (selected earlier) on the driveshaftin the order shown
rJ Position bearingwasher ,andshim(s) exactly N
r;gl12oI 22Lightly apply OMC Gasket SealinfJ, Compound to the
gearcase area that contacts mounting flange of the bearing housingDo not coat inside bearing housing bore surface of the gearcaseUsing OMC Driveshaft Seal Protector PIN 318674, slide the driveshaft bearing housing onto the driveshaft
23Pull up on the shift rod to engage FORWARD gearTurn the gearcase upside down by rotating the holding fixtureBe sure any excess grease is removed from the pinion needle bearingsDegrease inside taper of the pinion Position the pinion in the gearcase24Degrease the driveshaft taper and install the driveshaft25Lightly coat the threads of the pinion nut with outboard
lubricant and install on the driveshaftTurn the driveshaft by hand to engage the nut