1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 199Get this manual
r:;;;J 25V4Remove the water intake screen by depressing the tabs and pushing upwardInspect the screen for blockagePropeller Shaft Bearing Housing Service rl 1Remove both seals using OMC Puller Bridge PIN 432127 and OMC Large Puller Jaws PIN 432129Position the plate on top the housing to support the bridge, and tighten the jaws securely behind the lower seal t!J
Inspect bearings in placeIf bearing is removed for any reason, it must be discarded2Remove either bearing using OMCPuller Bridge PIN 432127 and OMC Large Puller Jaws PIN 432129Rest the puller plate on top of the housing to support the bridge, and tighten the jaws securely behind the bearing 3Discard the bearing housing O-ringClean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movementInspect O-ring groove, and sand off any sharp edges that would cut the O-ring and prevent its sealingV4Thoroughly clean the threads of the four bearing housing retaining screwsDiscard the retaining screws' sealsf31 4Inspect the bearing housing anodeReplace anode if it has eroded to two-thirds its original size