1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 197Get this manual
r:;;l 14Push down on the shift rod to engage REVERSE gear positionUnthread the shift rod from the detent leverRemove the six screws, shift rod, and cover assembly from the gearcaseDiscard the cover gasketRemove and discard the two O-rings from inside the cover15Remove the propeller shaft assembly from the gearcaserr7l 16Insert small screwdriver under one end of the clutch dog spring and remove it from the groove by unwrapping it from around the clutch dogDiscard the springf181 17Push the pin out ofthe clutch dog The bearing housing assembly will now pull out of the end of the propeller shaft and the clutch dog will slide off the splines COA3561
Pull the forward gearthrust bearingand thrust washer off the bearing housing
r:;;;l 19Push down on the detent lever to make sure it's in the most depressed positionLift out the shift shaft and cradle COA3562