1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 196Get this manual
COA3153
EI OMC Retaining Ring Pliers, PIN 331045Retaining rings
5V4If equipped, remove the two retaining rings using
are under extreme pressure during removal and installationWear safety glasses and proceed with care to avoid unsnapping the ring from your pliersAfterthe retaining rings are removed far enough from the gearcase to clear the housing, release pliers tension while the retaining ring is still around the propeller shaft
Remove the retainer plate from the gearcase
f81 7Remove the large thrust washer reverse gear from the gearcase
thrust bearingand
V6Remove small thrust washer, forward of the reverse gear
Remove the four driveshaft bearing housing screws with washers
f1Ol 9Pull up on the shift rod CD to engage FORWARD gearThis will provide necessary clearance to remove the pinion nutf1Ol 10Remove the pinion nut from the bottom of the driveshaft by using OMC Driveshaft Holding Socket PIN 311875 Q) and OMC Pinion Holder PIN 334455 Pad the handle of the holder to prevent damage to the gearcase