1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 188Get this manual
Propeller InstallationV6 These instructions apply when spacer is brassIf spacer is made of nylon, replace with brass spacer, PIN 320570
i pellers; twist and remove all spark plug leads2Place engine's shift lever in NEUTRAl
'" 1Avoid accidental starting of engine while changing pro-
rv taper of large propeller thrust bushing shaft and inner 3Apply OMC Triple-Guard grease to propeller
4Install thrust bushing onto propeller shaft with shoulder of thrust bushing facing aft5Install propeller on propeller shaft by aligning splines and pushing until it seats on the thrust bushing
[!] 6Install the spacerengaging the propeller shaft splines7Wedge block of wood between propeller blade and the anti-ventilation plate