1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 103Get this manual
Ignition Component Replacement Ignition Coil Removal
1Twist and remove the spark plug lead and primary leads from the ignition coils2Notice the fastener and washer orientation before removing any screws3Remove the coil mounting screws and remove the coil and washersIgnition Coil Installation
[";11Assemble the correct sequence of washers and locate the LJ ignition coil on the powerheadInstall and tighten the retaining screws to torque of 48-96 inIbs(5,4-10,8 Nm)2Apply light coating of OMC Triple-Guard grease to the ribbed portion of the spark plug ceramics and to the openings of each of the spark plug lead coversInstall the spark plug leadsr] 3Apply light coating of OMC Triple-Guard grease to the opening of each pri,mary lead cover and install the coversObserve proper wire routing and ignition timingDR1794