1993 Johnson Evinrude "ET" 90 degrees CV Service Manual, P/N 508285, Page 76Get this manual
I.J float should be between, but not touching, the notches of OMC Gauge, PIN 324891, as shown
f71 6Invert carburetor bodyWith float valve closed, top edge of
d 'H 324!" l2
If adjustment is necessary, do not put pressure on inlet needle
f81 7With the carburetor body in its normal position, adjust tab
on float hinge to obtain float drop dimension of 1s in(22-28 mm) f61 8Install intermediate fuel orifices using OMCOrifice Driver, PIN 317002Tighten securely9Apply OMC Locquic Primer and OMC Screw Lock to four float chamber screws10Install gasket, float chamber, and four screwsTorque screws in an "X" pattern to 24-36 inIbs(3-4 Nm)11Install the idle air bleed orifices in the carburetor12Install and securely tighten high speed fuel orifices 13Install O-rings on the float chamber drain plugsInstall and securely tighten drain plugs