1993 Johnson Evinrude "ET" 9.9 thru 30 Service Manual, P/N 508282, Page 326Get this manual
OMC Long Life TM CablesInstallation
OMCCable Adapter Kit, PIN 173600, must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control, and pull two halves apart39
13611371 2Place housing half
and cover half on flat surfaceApply OMC Triple-Guard grease to all points shown in figuresBe sure to grease the three cover screws' threaded holes
COB5630
1381 3Lubricate outside of brass sleeves at control end of both
remote control cables with OMC Triple-Guard grease
1391 4Place trunnion caps over cable trunnions and slide
casing guides over cable sleeves
1401 Using a
332 inhex wrench, start the set screws into each end of both control end wire clamps
14111421 To Begin cable installations with housing half of control6install throttle cable, make certain fast idle lever is