1993 Johnson Evinrude "ET" 9.9 thru 30 Service Manual, P/N 508282, Page 325Get this manual
3Lubricate cable ends with OMC Triple-Guard grease ra11 '"
i To install throttle cable, move throttle lever arm from
4Begin cable installation with housing half of control
behind plastic plate to expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever arm, in line with holesGrease cable pin CD and drop cable pin through upper lever arm, through eyelet, and into lower lever arm
13215Grease cable trunnion pocket and insert cable trunnion CMl
into trunnion pocket in housing halfr::;:;l 6The throttle lever must be in the idle position before
reassemblyMove it forward, toward the front of the housing half until it contacts the stop
13417To install shift cable, grease trunnion pocket in cover halfGrease cable pin, place eyelet of shift cable between the shift lever halves, and press cable trunnion into trunnion pocket in cover halfInsert cable pin