1993 Johnson Evinrude "ET" 9.9 thru 30 Service Manual, P/N 508282, Page 174Get this manual
1251 12Using tool as drawn on Page 4-9, or equivalent, push the taper pin toward the intake manifold surfaceDo not use any tool smaller than the taper pin bore to remove the pin[261 13Remove the six main bearing screws and eight flange screws1271 14Turn the powerhead with the intake facing up and then tap lightly upward on the crankshaft until the crankcase halves begin to separate15Lift the crankcase from the cylinder block12s Pi st;ns, rods, rod and retainers are weanng parts and seat With the operation of the engineBecause of this, it is essential to maintain their original positions at reassemblyUsing an indelible ink marker, mark each connecting rod, cap, and bearing component when they are removed to ensure correct mating, and keep the needles of each cylinder togetherLoosely install cylinder head to prevent pistons from falling