1993 Johnson Evinrude "ET" 9.9 thru 30 Service Manual, P/N 508282, Page 155Get this manual
1 Assembly
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
r:;l r:;] 1Using components from OMC Wrist Pin Retaining Ring LJ Installer and Pressing Pin, PIN 392511, seat new retaining ring in groove of the pistonWhen installed, gap of the ring should be positioned opposite groove in the piston
f31 2Using the piston cradle and wrist pin driver, oil and start the wrist pin into the piston wrist pin boss opposite where the retaining ring is installedDo not allow the wrist pin to enter the piston cavity
f41 f51 3Slide one of the wrist pin washers down the wrist pin
Position the top end of the connecting rod over the wrist pinApply OMC Needle Bearing Assembly Grease to the 22 needle bearings and install the bearings into the connecting rod