1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 272Get this manual
1431 7Push core wire CD (from engine end) through wire clamp Q) until wire is flush, 132 in(0,8 mm), with end of casing
1441 8Turn in set screw on large end of wire clamp until ittouches
core wire, then tighten one more full turn to kink and position core wire
1451 9Grease trunnion pocket in housing halfLift throttle cable
and rotate cable forward until trunnion cap can be inserted into trunnion pocket
1461 10Position throttle lever by hand to align rear hex screw
with access hole in controlInsert hex wrench through hole and tighten second set screw
1471 11The throttle lever must be in the idle position before
reassemblyMove the throttle lever forward, toward the front of housing half, until it contacts the stop