1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 271Get this manual
OMC Long Life TM CablesInstallation
OMCCable Adapter Kit, PIN 173600, must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control, and pull two halves apart
13611371 surfaceApply OMC Triple-Guard grease to all points 2Place housing half and cover half on flat
shown in figuresBe sure to grease the three cover screws' threaded holes
COB5630
138 3Lubricate outside of brass sleeves at control end of both
remote control cables with OMC Triple-Guard grease
1391 Place trunnion caps over cable trunnions and casing guides over cable sleeves
1401 5Using a
3 32 inhex wrench, start the set screws into each end of both control end wire clamps
4111421 6Begin cable installations with housing half of control