1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 231Get this manual
Starter Circuit CheckTTL
& To avoid accidental starting of engine, disconnect starter cable at CDNote Engine must be in NEUTRAL throughout test procedureBattery must be fully charged
Procedure
Results
II Check voltage to cable at CD
Connect voltmeter between cable at CD and groundTurn key switch to ON positionPress start button Connect voltmeter between and ground
If meter shows 12 volts, test starter If meter shows Step
a volts, go to
fa Check voltage at II Check voltage at II Check voltage at
If meter shows 12 volts, go to Step
If meter shows volts, test battery and cablesConnect voltmeter between and groundPress start button If meter shows 12 volts, go to Step If meter shows volts, test start button, key switch, and wiring If meter shows 12 volts, proceed to Step If meter shows volts, replace solenoid or lead If meter shows place solenoid