1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 221Get this manual
6Examine the pulley and the starter housingLook for sharp edges and rough surfaces that could fray the starter rope File and polish to remove 7Examine the starter and the starter lockout partsReplace any worn or damaged partsAssembly
i manual starters because of rewind spring tension
'" Wear safety glasses while disassembling and assembling
[!TI 1Place the starter spring shield into the starter housing1121 2Using OMCSpecial Tool PIN 392093 (Starter Spring Winder and Installer), clamp spring winder base in viseInsert
release plate into spring winder base
G31 3Apply OMC Triple-Guard Grease or Lubriplate 777 to the
rewind springInstall the rewind spring into the spring winder base with open loop of spring facing inwardInsert the pin of the crank and pin assembly into the loop of the rewind springSecure the crank and pin assembly to the starter winder base with the crank retainer screw