1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 212Get this manual
20Align the bossed word "FRONT" toward the shift rod and push the driveshaft bearing housing in positionApply OMC Gasket Sealing Compoundto the threads ofthe housing retaining screwsInstall the screws and tighten the screws little at time to press the bearing housing down evenlyTighten the screws to torque of 96-120 inIbs(11-14 Nm)r;:;l r,;;;] 21 Place the smaller thrust washer in recess of the reverse gearOil, then install first the thrust bearing and then the larger thrust washer on the hub of the reverse gearSlide the reverse gear onto the propeller shaft until it engages the pinion 1631 22Slide the bearing housing retainer plate into position over the propeller shaft1641 '" 23Using O"1C:Reta.ining RingP.liers 331045, install the two retaining nngsRetaining nngs are under extreme pressure during installationWear safety glasses and proceed with care to avoid unsnapping the ring from the pliersLook inside the gearcase and make sure that the retaining rings are seated in the grooves in the gearcase