1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 209Get this manual
Assembly Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection, Page
After the gearcase has been thoroughly cleaned and inspected, install new pinion bearing in the gearcase as follows:
1 Assemble the following components of OMCPinion Bear4311ing Remover and Installer PIN 391257 as shown
-20 V2 inHex Head Screw PIN 326584 Spacer in0.0Flat Washer
PIN 326582 Rod PIN 326575 Installer -20 inHex Head Screw PIN 391260 Plate
2Place the bearing on the installer tool with the lettered side of the bearing facing the toolUse OMC Needle Bearing Assembly Grease to hold the bearing on the tool3Insert the tool with the bearing into the gearcaseDrive the bearing into the gearcase until the washer on the tool contacts the spacer
COA3082