1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 151Get this manual
Assembly
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard LubricantNote Use new gaskets, seals, and a-rings during assemblyr:jl1Apply OMC Needle Bearing Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearing in the bore using OMC Wrist Pin Bearing Tool, PIN 336660f211al2Place the two wrist pin thrust washers on the tool with flat side of the washers facing out'413The connecting rod has no specific orientationSupport the piston in OMC Piston Cradle, PIN 326573Oil the wrist pin bore and wrist pin'414Install the wrist pin through the piston and connecting rod, pushing the tool out through the piston1sl1sl5Using OMC Cone, PIN 318600, and Drive, PIN 318599, install new wrist pin retaining rings in each wrist pin holeGap of the retaining ring faces down away from notch in piston6Repeat Steps thru for each pistonDR1641