1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 122Get this manual
3 STEPSTOP CIRCUIT TEST
Elimination Test
[!] 1Disconnect 5-pin Amphenol connector between stator assembly and power pack2Eliminate stop circuit by inserting jumper wires in the "A", "B", "C", and "0" terminals of both connectors&
To avoid possible shock hazard, do not handle ignition coils or spark tester during cranking tests
3Crank engine and observe results at spark tester If spark now jumps alternately at each gap, the problem is in the stop circuitGo to Ohmmeter TestStop Button or Ohmmeter TestKey Switch If some spark is present, go to STEPSENSOR COIL If no spark is present, go to STEPCHARGE COIL TEST4Complete all circuits disconnected during this test