1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 109Get this manual
Ignition Coil Replacement Removal
1Twist and remove cover to remove the spark plug and primary leads from the ignition coilsr:jl2Notice the fastener and washer orientation before removing LJ any screws3Remove the screws, coil, and washersDR2780
Ignition Coil Installation
[";11Assemble the correct sequence of washers and locate the LJ ignition coil on the powerheadInstall and tighten the retaining screws to torque of 48-96 inIbs(5,4-10,8 Nm)2Apply light coating of OMC Triple-Guard grease to the ribbed portion of the spark plug ceramics and to the openings of each of the spark plug lead coversInstall the spark plug leads3Apply light coating of OMC Triple-Guard grease to the opening of each primary lead cover and install the coversObserve proper wire routing and ignition timing: orangeblue lead to No.1, orangepurple lead to No.2, and orangegreen lead to No.3