1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 86Get this manual
2Install float valve seat and gasket 3Install inlet needle, clip, float, and hinge pin
valve closed, the float's top edge should be between, but not touching the notches of OMC Gauge PIN 324891, as shownINotellf adjustment is necessary, do not put pressure on the inlet needle
r:J3l4Adjust float levelInvert the carburetor bodyWith the float
11415Adjust float dropWith carburetor body in normal position, the float drop dimension should be 1Va to in(28-41 mm)11216Install nozzle well gasket 7Install float chamber gasket 8Apply OMC Locquic Primer and OMC Screw Lock to the float chamber screws9Install float chamber and four screwsTorque screws in an "X" pattern to 25-35 inIbs(2,8-4,0 Nm)