1993 Johnson Evinrude "ET" 60 thru 70 Service Manual, P/N 508284, Page 47Get this manual
r;;;l '" 4Stop the engineTo adjust, turn the idle speed screw clockwise to achieve specified timing 5Repeat Steps and 3This procedure should provide the best idle characteristics while allowing engine idle speeds in gear ranging from 750 to 850 RPM, depending on propeller selection If idle speed is too high, check induction system for air leaks If idle speed is too low when engine condition is correct, decrease idle timing to achieve desired RPMExample: from ATOC to ATOCThrottle Cam
11511Verify the throttle arm is firmly against its idle stop
[":;';12Hold the coupler shell on the coupler ball with light pressureRotate the cam follower and inspect the clearance between the follower and the throttle camIf the cam follower does not touch the cam and the clearance between the cam and follower is less than 0.010 in(0,25 mm), the adjustment is correct