1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 313Get this manual
Installation
1Place trimtilt unit into positionApply OMC Triple-Guard grease to the lower pin, and install the pin
2Install external snap rings in lower pin with sharp edge of ring facing out3Extend tilt cylinder rod to match with holes in swivel bracket1]4Apply Triple-Guard grease to upper pin, and install the pinI.nstall external snap rings onto upper pin with sharp edge out[!] 6Attach ground wire to the motor retaining screw'4'7Route wires inside braided tube through stern bracket, and bullet and two pin connectors