1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 296Get this manual
'(continued) If no voltage at V3, disconnect bluewhite tilt limit switch bullet connectors and re-connect to by-pass tilt limit switchRepeat Step 7If you now have voltage at V3, adjust or replace tilt limit switch If voltage at V3, go to Step 8IReinstall one relayPush blades only halfway into bracket in UP (blue) end of bracket TI
9Push UP trim button and check for voltage at V4 on relay blade (M terminal of relay) If no voltage at V4, go to Relay Ohmmeter Test If voltage at V4, go to Step 10
10Disconnect trim motor's blue and green power wire connector (leave relay in bracket)11Push UP trim buttonCheck for voltage on blue wire If no voltage on blue wire, check blue wire from relay bracket to motor connector If voltage on blue wire, check motor and leadCIRCUIT
12Remove relays from relay bracket
!] 13Connect voltmeter red lead to V5 and black lead to V6 If no voltage at V5, check red wire between starter solenoid terminal and relay bracketIf red wire is OK, check black wire between relay bracket and engine ground If voltage at V5, go to Step 1411 14Connect voltmeter black lead to clean engine ground, and voltmeter red lead to V7 (greenwhite)