1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 274Get this manual
Installation of Cables on Engine i cables are disconnected at batteryThrottle Cable 1Remove the anchor block cover from starboard lower engine coverRemove cable retainerApply liberal amount of OMC Triple-Guard greasef1l 2Extend throttle cable and lubricate with OMC Triple-Guard grease3Verify that the remote control fast idle lever is down in the RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustmentFailure to follow this procedure exactly might cause accelerated wear of shift system components and high shifting effort5Remove the timing sensor coverBe sure the timer base lever is against stop on the flywheel cover'" To prevent accidental starting of engine, verify that battery