1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 243Get this manual
Assembly
If removed, apply OMC Locquic Primer and OMC Screw Lock to the brush card screws before installing1Place armature in frame
1181 2Apply OMC
Pressure Grease to the brush holder
cap armature bearmg
3Correctly route the brush leads and install the springs and brushesIncorrect orientation of thebrushes could damage the starter or cause reverse rotationr:t9l 4knifethe brushes and springs with modified putty
5Align and place brush holder cap firmly on armature and slide putty knife out, making sure the brushes are retained properly
1201 6Install thrust washer, and align and place end cap onto