1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 222Get this manual
rcl r:;l 9Assemble remaining shims, new tab-lock washer, and impeller nut onto driveshaftTorque impeller nut to 16-18 ftIbs(22-24 Nm)Use new tab-lock washer each time, and bend tabs around driveshaft nut to securer:;] 10Assemble intake housing to main housingApply OMC Gasket Sealing Compound to threads of six retaining screws and install them finger tight only
Check for any rubbing or binding between the casing liner and impellerIf clearance is greater on one side, verify that the intake housing is centeredTorque screws in crisscross pattern to 10-12 ftIbs(14-16 Nm)
[!] 11Repeat Step to verify adjustmentGate Adjustment
1Move remote control handle to NEUTRAL detent