1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 220Get this manual
Installation
rv seal innerOMC Adhesive sealantnewlower exhaust housing1Apply to housing surfacesPosition two seals on
Apply OMC Triple-Guard grease to seal outer surfaces and position housing on jet drive housing2Slide jet housing into place, making sure driveshaft engages crankshaft, water tube enters water pump, and lower inner exhaust housing does not slip out of positionf313Apply OMC Gasket Sealing Compound to threads of jet housing retaining screws and rear exhaust housing screwInstall two 38-16 212 inscrews in forward holes and two 38-16 inscrews in rear holes Install rear spacer and screwTorque all screws to 18-20 ftIbs(24-27 Nm)4Install key, bushing, shims, tab-washer, and nut on driveshaftBe sure shims are placed in original positionRefer to Impeller Clearance Adjustment5When proper clearance adjustment is achieved, torque impeller nut to 16-18 ftIbs(22-24 Nm)