1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 215Get this manual
101 13To assemble inner and outer seals to bearing housing, install outer seal retaining ring into its groove in the bearing housing
1nl 14Apply OMC Gasket Sealing Compound to metal casing of each seal before installingApply OMC Triple-Guard grease to seal lips before installing inner sealInstall outer seal into bearing housing with lip facing outwardPress seal in until it makes contact with retaining ring
f10l f111 15Install inner seal with lip facing outwardTap seal into
f121 16Remove the seal carrier assembly and thrust washer from the driveshaft17Remove the retaining ring with retaining ring pliersWear safety glasses and proceed with care to avoid unsnapping the ring from the pliers