1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 199Get this manual
1351 21Push the propeller shaft out of the bearing housing1361 22Remove the thrust bearing and thrust washer 1371 23Remove both seals using OMCPulier Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Position plate on top of housing to support bridge and tighten jaws securely behind lower seal
Inspect bearings in placeIf bearing is removed for any reason, it must be discarded
24Remove either bearing using OMCPulier Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Rest puller plate on top of housing to support bridge and tighten jaws securely behind bearing25Clean housing and bearings in solvent and dry thoroughlyIf bearings were not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring groove and sand off any sharp edges that would cut O-ring and prevent its sealing 1391 26To replace the large bearing, lightly coat the outside case