1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 194Get this manual
f61 f71 8Pull up on the driveshaft to remove it from the gearcaseThe driveshaft to pinion taper is locking taperIf necessary, use OMC Puller, PIN 390706and OMC Backing Plate, PIN 325867 CD, to break the lockInstall the tools as shown by clamping them around the driveshaft with the tool's set screw aligned with the water pump drive cam slotThen, tighten the set screw into the slotAlternately tighten the two vertical screws against the backing plate inserted between the puller and the gearcase until the driveshaft pops loose from the pinion, then remove the tools1a1 9The bearing housing Q), shimsthrust bearing Ch), and thrust washers will come out with the driveshaft 19l 10Reach inside the gearcase and take out the pinion, nut, and
any loose needle bearings that may have fallen into the gearcase